2010-2013 Acura MDX Driver Side Fog Light with Bulbs | DOT Certified | Replacement Part #AC2594101 & 33951-STX-A11 | Perfect for Night Driving & Foggy Conditions

My experience with aftermarket parts has been hit and miss. They may perform the function but they just don't look like the factory original. In this case, the part was a precise reproduction from the factory original. The factory original had a broken tab that retains the light in its location so the light would not stay in place so I finally got around to replacing it. I can say this light is an exact duplicate of the original. You can not tell the difference other than the fact it simply looks new. This was about 1/2 the price of a OEM replacement and unless you are looking at the markings on the back of the light which are not visible once installed, you simply would not know the light is not original. The light was well packaged with a clear film to protect the lens. I recommend leaving the film on during installation as you will be able to remove the plastic film without the edges getting trapped after it is installed. There is some disassembly required to install this light but not as much you might think. I replaced the passenger side only but same process will work for either side. I jacked the car up on level ground and placed a jack stand under the rear lower control arm to support the vehicle. With tire removed, I removed the push clips in the fender well up to the middle of the wheel well, basically, 1/2 of them plus one screw. With this done you can flex the wheel out of the way. Underneath the bumper, I removed about 1/2 the push clips and 1 screw that ties the fender to the bumper. With this done, I used (2) 2X4 wood blocks in the shape of a square to fit between the frame and the bumper so that there is enough space to access the bolt that holds the light in place. In this configuration, when installing the new light, you can use your left and hand to hold the bolt and feel where the alignment is as you the push in the new light and then you can finger tighten. Once the part is started the same 2X4's that created for you hand to fit over the lower bumper, will allow a small ratchet to access the bolt to tighten. I would highly recommend push pin pliers for this. It took me about 20 minutes from start to finish to complete the install.works good, looks good